John’s Heating, Cooling, and Plumbing has been Gilberts's go-to HVAC Experts since 1970. During that time, we have serviced, maintained, and replaced hundreds of units and helped our community neighbors upgrade their systems with new, more energy-efficient ones. We’re the company you can trust. Browse our case studies below and call us today at 480.649.1000 to schedule a service call or installation estimate.
When our customer’s furnace wasn’t reaching the set temperature, they called Johns to diagnose the problem. It turned out, their entire furnace was unoperational and they needed a new one. They decided to get a brand new 5 ton Trane furnace. To ensure optimal system operation we installed a new trapeze, a full size pan, and insulated plenums with dampers. For safety we also installed a new gas shutoff valve and whip, a new flu vent, and a new safety switch. To maximize efficiency we sealed all the connections and ran a direct supply to the plenum. The customer also received a new disconnect with a whip and a new condenser pad. Our customer will enjoy years of comfort and peace of mind with a 10 year parts and 20 years heat exchanger warranty. We also provide our “Installed Right” Guarantee and our Money-Back Guarantee for the first year of its performance.
Our customer called Johns because they were not getting cool air from their 11-year-old unit. We went over and found the system’s filter and evaporator were plugged-up, the low voltage wires frayed, and the condensation drain broken. We also found that water had flooded the inside so badly over time, it caused the bottom of the unit to be rusting out! The unit was in such bad shape the evaporator was also rusting and at risk of leaking Freon. The customer decided to have us replace their old unit with a new 3 ton 2 stage Trane Heat Pump. We added a new stand, a new P trap and PVC, and a new disconnect and whip with a surge protector. We installed a wire kit for 2 stage cooling and a cut in a 12” return before sealing all connections thoroughly. This system is covered by a 10 year warranty and backed by John’s exclusive installation guarantees.
We installed two Trane air conditioning systems in this Gilbert, AZ home. Included are a new full-size pan, new insulated plenums with dampers, new gas whip and shut-off valves, and new flu vents. Sealed all connections. New disconnects with whips and pads. Complete start-up and QCA were achieved, ensuring both systems are ready for their new home with our happy customer.
We were called out to this customer’s home. The outside AC unit was not turning on. Since the current system was old, it was decided that replacement was necessary. We installed 2, 3-ton Trane furnaces and air conditioning systems. New full-size pan, new gas shut-off valve and whip, new flu vents, and a new drain line with safety switch were also installed. New insulated plenums with dampers were installed and we sealed all connections. New disconnect with whip. Complete start-up and QCA were achieved. These systems are covered by 10 years parts, 10 years compressor, 20 years heat exchanger, and 2 years labor guarantees.
This customer’s heat pump failed and needed to be replaced. We Installed two heat pumps, 2 4-ton 2-stage Tranes. A new full-size pan and new insulated plenums with dampers were installed as well as new p traps with safety switch and A new 824 thermostat. We then sealed all connections. Complete start-up and QCA were achieved. Both systems are covered by a 10-year parts, 10-year compressor, and 2-year labor guarantee.
A John’s customer contacted us because no cool air was coming from their air conditioner. This customer has two older HVAC systems in their home. After discussion, the customer decided to entertain estimates for new system and opted to replace the old systems with newer and more energy efficient Trane 3 & 4 ton, 2 stage, Seer 2 split units with outdoor condensers and coils. All of these are covered with John’s impeccable installation and replacement guarantees. Another customer saved from the Arizona heat!
We installed 2 new Trane single stage split systems with A/C coils and furnaces located in the attic. Condensers were installed outside of the residence. The furnaces were installed with new supply and return boxes, collars with dampers, safety switches, full length pans and all duct work at the unit was sealed. The condenser was installed with a new disconnect, whip, and surge protector. We did a complete start up and QCA. 10-year parts, 10-year compressor, 20-year heat exchanger, 2-year labor warranties.
A new customer to John’s Heating, Cooling, and Plumbing was calling around to local HVAC companies to get estimates on a heat pump replacement for their 30-year-old system. They scheduled a free no cost estimate, were given a quote, and decided to move forward with John’s for their heat pump replacement. The techs installed a new Trane 14.3 Seer Split Heat Pump with Standard Air Handler located in a closet in the customer’s home. Additionally, they installed a condensate safety switch into primary drain line after clearing out drain line and a new Honeywell T4 pro thermostat. This home is also Pearl Certified, which is a comprehensive report that can increase your home's value by an average of 5% by highlighting the high-performing assets that make your home healthy, comfortable, and energy efficient when it’s time to sell or refinance.
A new customer to John’s was looking to schedule a no-cost new unit consultation to replace their old heat pump and air conditioning that used R-22. After reviewing their written fixed-price quote, they decided to move forward with John’s for their HVAC replacement. We installed a Trane 14.3 Seer Split Heat Pump with Standard Air Handler. Additionally, we installed and hung a new trapeze for the air handler which was located in the attic, installed a new full-length drain pan with redwoods to reduce vibration noises, and a condensate safety switch into the primary drain line. Lastly, we installed new return and supply plenum boxes, hooked up all ductwork to plenum boxes, and sealed all connections and penetrations to system. The new system is backed by a 10-year parts, 10-year Compressor, and 2-year labor warranty on top of all of John’s Installation & Replacement Guarantees.
A Peak Performance Maintenance member called John’s Heating, Cooling, and Plumbing to schedule their seasonal maintenance for both of the systems at their house. When the tech arrived for the inspection, the customer wanted to discuss a replacement quote they were presented with during their last visit and was curious if the pricing was still accurate. It was, so the customer decided to move forward with replacing their systems for increased comfort. We installed Trane 18 Seer Communicating Variable Speed Heat Pump with Variable Speed Air Handlers, a new filter base with a filter for the air handler, new transition duct work for the air handler, and a new condensate pump. A surge protector was installed on an electrical disconnect outside to protect the system from surges, which is crucial to have in our Arizona climate. Lastly, a new communicating Nexia thermostat was installed for unit. The new system is backed by a 10-year parts, 10-year Compressor, and 2-year labor warranty on top of all of John’s Installation & Replacement Guarantees.